restore 2 or 4 layer layout fails

[kernelport]

In this simple test project, I evaluated the SaveRestoreLayout plugin in Kicad 7.
https://github.com/kernelport/TestKicadSaveRestoreLayout/commits/main
The problem is that it only restores the top layer. All other layers are ignored, including vias.

Could it be that only the top layer is supported? Or is it a bug?

With kind regards

[MitjaNemec]

It should restore all layers. so there might be a bug. Can you attach a test source and destination projects.

Also be advised, my schedule for September is quite full so you'll probably need to wait for bugfixes.

[kernelport]

It should restore all layers. so there might be a bug. Can you attach a test source and destination projects.
This is my test source and target project, it contains also the save and restore logs:
https://github.com/kernelport/TestKicadSaveRestoreLayout/commits/main

OK,it should restore all layers including vias. Fine!
I had a look at:
/tmp/temp_board_file_for_save.kicad_pcb
At this stage the whole pcb is there. That is not the problem.

Also be advised, my schedule for September is quite full so you'll probably need to wait for bugfixes.
For me, it's not that urgent. Thank you for watching this

[MitjaNemec]

If you can share the existing project that would be awsome. Even attaching save_restore_layout.log file would maybe help a bit

[kernelport]

If you can share the existing project that would be awsome. Even attaching save_restore_layout.log file would maybe help a bit

I did this already, see my github repo:
https://github.com/kernelport/TestKicadSaveRestoreLayout/tree/main